| T O P I C R E V I E W |
| davesalmon |
Posted - 02/10/2019 : 18:51:14
If this has happened before, I have not noticed it. Using Nokia 8 which has internal baro.Today flying in wave up to FL100 the baro height, disappeared briefly every 5/6 seconds, and at the same time the FL readout changed down a flight level, and then back up again when the baro height re-appeared.
I had a V2 running as well connected to Flarm showing the Flarm radar screen, and the same bottom bar as the Nokia. The problem did not occur on that.
I suspect it is a phone problem not LK8000, but any ideas please? |
| 3 L A T E S T R E P L I E S (Newest First) |
| brunotl |
Posted - 19/10/2019 : 14:41:34
after investigate, it's a drawing artefact, that can happen in all platform... |
| davesalmon |
Posted - 04/10/2019 : 15:23:10
There is nothing written in the runtime log, and there are no missing alt readings in the logger file B records. The baro alt was coming from 2 sources, internal and from Flarm via BT, so difficult to understand why both went missing. When the baro alt reading disappeared it was replaced for a second by the --- mark. I don't know if it started straight after takeoff, because initially I was concentrating on finding the wave lift in the blue,but once I had noticed it, it continued for the rest of the flight at the 5/6 second intervals.
Will look out for it next time. |
| brunotl |
Posted - 02/10/2019 : 23:56:49
when baro sensor stop to send data, we write line inside runtime.log, you can check that first... |
|
|
