|
mejbeekman
Pulcino
6 Posts |
 Posted - 08/04/2012 : 21:38:24
|
In addition, I have another question regarding the AAT:
I was wondering what the reasons are that sometimes LK8000 uses the manually set target and sometimes the centre of the area.
- direction: the direction is set at the target, as one would expect. When one enters the area, this is still kept at the target when one progresses manually through the task.
- distance: the distance as indicated in the left top corner is calculated to the target.
- arrival height: in combination with the above results, one would expect that the arrival height would be calculated at the target. This is however not the case. The arrival height is calculated to the centre of the area.
I was wondering whether there is a special reason for this, or whether this could be changed? |
Edited by - mejbeekman on 08/04/2012 21:40:24 |
 |
|
AAT
